RegisterRegister 
 
Classified AdsClassified Ads Search AdsSearch Ads
MSW NAVIGATOR
New Page 1

New Page 1


New Page 1

 


Your Details
Username:

Password:

 Remember me



I forgot my password

Don't have an account yet?
You can register for FREE


Who is Online?

In total there are 59 users online :: 16 Registered, 0 Hidden and 43 Guests

Registered Users: bbusa, chach_86, coater87, Darius359au, dr_hemlock2, dustman1973, Ferrux, flyboy441, Garward, javimetal, Padreh, popeye_the_sailor, riverboat, spud, w33, Zarko

[ View complete list ]


Most users ever online was 209 on Tue Jun 26, 2007 2:15 pm


New Page 1

Member of International List of Scale Model Related Web Sites


Simple Hull Planking Techniques for Beginners


2. Bearding Line

Figure 2:

This is a term used to indicate the tapered section of the false keel at either the bow or stern of the model. It is a section where extended tapering is required to allow the hull planks to lay flat against the false keel. This taper is variable from point to point and is shown on your plans and must be adhered to, to enable you to construct a faired model. Figure 2 shows a simple method of cutting the bearding line with a sharp chisel being careful not to cut above the indicated dotted line of your plans. There are numerous other ways to carry out this operation but to make this exercise a simple matter among them are sand paper over a wooden block or the use of power tools such as a Dremel with a sanding drum are as good as any. It is really just a matter of builder preference and whatever tools he has available to him.

Sections AA, BB, CC show an approximate finished shape that will need to be obtained. Again this is approximate and the correct shape for your particular model can be obtained from the kits plans.

 

Important:

Take your time with this operation and do your best as it is important to the successful outcome and appearance of the model.

 

 

Last Page     Next Page

Simple Hull Planking Techniques      Home      Index



Skin Created by: Sigma12
Powered by phpBB © 2001, 2002 phpBB Group
Cache Posts System © 2006 AmigaLink