Album created by
192 Scale USS Ohio SSGN version scratch built for her commanding officer
Thank you for your further explanations!
I have now a good understanding of the principle of how you made the case. I am looking forward to your additional photos! No hurry from my side, because there is still a lockdown in my country, so I cannot buy materials...
I intend to make my case 102 cm by 35 cm wide and 75 cm height. I assume that this is close to your dimensions (and weight...).
Yes, it took 2 people for the large panels. Most of your statements are correct, the top was done differently. They are only rectangular strips that fit into a shoulder I milled on the outside tops of the verticals deep enough so the strip (when attached) make the outside edge of the glass trough (of the verticals) allowing the panels to slide in and out. Then the cover is screwed to the verticals locking the whole thing together. The total weight of glass would have been ~ 160 lbs so I went with Plexiglass which was only about 75 lbs but more expensive. I under estimated both the weight of material as well as the cost for a case this size. I will try to post (or send to you directly) photos to help explain, however, it is at my sons house so it may be a few days. In the meantime let me know if you have any questions and thanks for your interest.