Jump to content

Wütender Hund by ccoyle - Shipyard - 1/72 scale

Wütender Hund by ccoyle - Shipyard - 1/72 scale
ccoyle
Album created by
ccoyle
  • 17
  • 0
  • 8

This is the first wooden kit offered by the Polish card model publisher, Shipyard. It represents a cog (or kogge) used by privateer Klaus Störtebeker in the latter half of the 14th century. Full build log can be viewed here.

0 Comments

There are no comments to display.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Add a comment...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Image Comments

    • No worries Bob....always learning, the best part about all of this....
    • Beautiful model! I have the POB on the shelf for a future build down the road. Thanks for explaining your paint and stain scheme.
    • Hi Mike,
      Thank you for your further explanations!
      I have now a good understanding of the principle of how you made the case. I am looking forward to your additional photos! No hurry from my side, because there is still a lockdown in my country, so I cannot buy materials...
      I intend to make my case 102 cm by 35 cm wide and 75 cm height. I assume that this is close to your dimensions (and weight...).
      Andre
    • Yes, it took 2 people for the large panels. Most of your statements are correct, the top was done differently. They are only rectangular strips that fit into a shoulder I milled on the outside tops of the verticals deep enough so the strip (when attached) make the outside edge of the glass trough (of the verticals) allowing the panels to slide in and out. Then the cover is screwed to the verticals locking the whole thing together. The total weight of glass would have been ~ 160 lbs so I went with Plexiglass which was only about 75 lbs but more expensive. I under estimated both the weight of material as well as the cost for a case this size. I will try to post (or send to you directly) photos to help explain, however, it is at my sons house so it may be a few days. In the meantime let me know if you have any questions and thanks for your interest.
      Mike
    • Hi Mike,
      Thank you for taking the time to explain. I understand somewhat better. If you would share additional photos: that would be great!
       
      I have understood that your horizontal wooden strips have an extenting part at the bottom so that it fits into the base grooves. I assume my milling the excess away.
      Is it the same construction at the top?
      I have seen in your photos that the glass is held in place by clip-skrews. I assume that the horizontal wooden strips at the top are only at the outside, to allow the sliding of the glass?
      Did you need assistance for sliding in the big glass panels, because of the weight?
       
      Thanks! Andre
       
  • Gallery Statistics

    18,739
    Images
    5,600
    Comments
    1,709
    Albums
×
×
  • Create New...