Jump to content

Recommended Posts

So I'm building the super popular da Fran II. Had this great idea to rig my cannons like I would on my next build (rattlesnake ms). So attached eyebolts to the bulkheads got my blocks all set up and went to rig my first cannon and the distance between the bulkhead and cannon was to say the least not enough. It looked like a train wreck. So my question is there alternative rigging souloutions for cannons that are somewhat realistic? The pic below is an idea I had to maybe rig the cannons. Any feedback is greatly appreciated. post-1401-0-46554500-1363317382_thumb.jpg

Nothing is glued down or perminate and none of the line have been trimmed

Edited by sport29652

Eric

 

Current build(s) ;

AL San Francisco II

http://modelshipworld.com/index.php?/topic/862-san-francisco-2-by-eric-al-190-sport29652/

 

MS Rattlesnake

http://modelshipworld.com/index.php?/topic/868-rattlesnake-by-eric-model-shipways-164-sport29652/page-2

 

Sitting on the shelf : MS Constitution, MS Sultana,

 

Wish List : MS Essex, Confederacy, and Syren, and a Victory kit by someone ?

 

"80% of the time it works every time."

Link to comment
Share on other sites

sport29652

 

The appearance of the woodwork looks very nice.   Regarding your request for feedack on the cannon rigging, couple suggestions, so hope you don't mind.  It looks like you ran the running rigging through the eyes where there would be another block.  The blocks that you do have there appear to be oversized, which may be the reason it did not look right in your earlier tries. For the blocks that you did use, the hole in the blocks through which the line passes should be towards the bulkhead.  The missing blocks would have the holes opposite. The ends of the lines were more likely frapped rather than coiled on the deck.  Again hope you don't mind the comments.  

 

Allan

PLEASE take 30 SECONDS and sign up for the epic Nelson/Trafalgar project if you would like to see it made into a TV series.   Click on http://trafalgar.tv   There is no cost other than the 30 seconds of your time.  THANK YOU

 

Link to comment
Share on other sites

No thank you so much for the feedback. It's exactly what I'm looking for. I have a diagram for my rattlesnake that shows the rigging (proper). The huh moment I'm having is that these are the smallest blocks I could find, 3mm I think. So it looks like ill either have to make my own or go shopping. Again thank you for the feedback

Eric

 

Current build(s) ;

AL San Francisco II

http://modelshipworld.com/index.php?/topic/862-san-francisco-2-by-eric-al-190-sport29652/

 

MS Rattlesnake

http://modelshipworld.com/index.php?/topic/868-rattlesnake-by-eric-model-shipways-164-sport29652/page-2

 

Sitting on the shelf : MS Constitution, MS Sultana,

 

Wish List : MS Essex, Confederacy, and Syren, and a Victory kit by someone ?

 

"80% of the time it works every time."

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...