bluenose2

Bitts and belaying pin racks.

Hello Les here. I have a question about the posts for bitts and belaying pin racks.The tops of these posts are tapered. Is there a way to set up a production line for tapering the tops ? I have many to do>

Share this post


Link to post
Share on other sites

Did you mean that they are bevelled ? If that, I would make a sanding jig for this, so that you can hold them at a 45° (or any other appropriate) angle. That jig also should have stop, so that you can offer all sides of the bits etc. at the same distance to the sanding block in order have the bevel equal.

 

I you have a milling machine, of course, you can also make a jig for use on that one.

druxey, mtaylor, bluenose2 and 1 other like this

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now

  • Recently Browsing   0 members

    No registered users viewing this page.