Jump to content

panofish

Members
  • Posts

    1
  • Joined

  • Last visited

  1. I just installed my QCTP from A2Z on my sherline. It was purchased months ago. I had exactly the same experience as you. The toolpost is about 1/4" too short and the mount bolt is about 1/4" too long. My solution was to shorten the bolt. Then when I put a 1/4" tool in the holder... I added another 1/4" tool blank below the tool. The 4 lock bolts work fine to hold it in place. A 1/4" tool placed on the lower edge of the holder is too low and won't work. Perhaps a 3/8" or 1/2" tool may work... I haven't test yet.
×
×
  • Create New...