Search the Community
Showing results for tags 'elijah'.
Hello all! This will be my build of the Continental Gunboat Philadelphia. A brief history of her is taken from the model shipways website. "Launched in August of 1776, the gunboat Philadelphia is the oldest American fighting vessel in existence. Part of the American fleet commanded by General Benedict Arnold, she sank on October 11, 1776 during the Battle of Valcour Island against the Royal Navy on Lake Champlain. She remained sitting upright in the cold waters of the lake until she was raised in 1935. Today, she’s on permanent exhibit at the Smithsonian Museum in Washington, D.C., complete with 24-pound ball that sent her to the bottom. " Length 26-3/8” Width 13-3/4” Height 24-5/8” Scale 1:24 (1/2” = 1 ft.) The actual gondolas built by Benedict Arnold were armed with two nine pounders, one twelve pounder and a few swivel guns. Arnold's gondolas were around 53 feet long with 15 1/2 foot beam and 2 foot draft. An overview image from the website is the following. The first few steps were pretty simple. I removed the parts I needed for the keel, stem and sternpost and glued them together. The keel was very straight with no noticeable war page. I sanded most of the laser char off. The pieces of wood that form the rabbets are pretty simple to carve. I just used an Xacto blade and a sanding block. There are also the visible parts of the stem and sternpost a which get narrower towards the ends. I have yet to make these rabbets at the bow. That's it for now. Thank you for looking in!