Jump to content
tlevine

tlevine Carving Attempt with Hand Tools

Recommended Posts

As I have never done any carving, I have decided to join this Group.  I am using a combination of a #11 scalpel blade and a 1.5 mm micro-chisel.  

 

My first step was to glue the blank onto a piece of scrap wood with yellow Elmer's.  I clamped it in place for an hour before getting to work and then scraped off most of the laser char.  As recommemded, my first task was to make the stop cuts.  The key here is to only take off a tiny piece until one is happy with the effect.  In addition to the red lines shown in Chuck's sketch, I added stop cuts on various spots of the crown, looking at what Chuck did for guidance.  Finally, I have started to smooth down the corners.  The last picture was taken to better illustrate the depth of the cuts.

 

Next, I will make up some 400 grit sanding sticks to improve the surface finish.

 

post-262-0-87838600-1478038832_thumb.jpg

 

post-262-0-36571500-1478038851_thumb.jpg

 

post-262-0-02830500-1478038866_thumb.jpg

Share this post


Link to post
Share on other sites

No fair....for you its just like cutting out a gall bladder.   You must do that that ten times a week. :P

 

But seriously,  that looks very good  I hope you had fun with it.  I am curious how folks will think about the removal process.   Dunk it in some alcohol and give it a go.

Share this post


Link to post
Share on other sites

I cleaned up the carving with some 400 grit wet-dry sandpaper and removed the carving from the blank by soaking in isopropanol for an hour.  As you can see, I lost the tip of the bottom of the "R".

 

post-262-0-66616200-1478192720_thumb.jpg

 

Next, I gold leafed it and applied a satin sealer.  I'll try the other carving in a few weeks.  

 

post-262-0-71663600-1478192735_thumb.jpg

 

 

Share this post


Link to post
Share on other sites

  • Recently Browsing   0 members

    No registered users viewing this page.

About us

Modelshipworld - Advancing Ship Modeling through Research

SSL Secured

Your security is important for us so this Website is SSL-Secured

NRG Mailing Address

Nautical Research Guild
237 South Lincoln Street
Westmont IL, 60559-1917

About the NRG

If you enjoy building ship models that are historically accurate as well as beautiful, then The Nautical Research Guild (NRG) is just right for you.

The Guild is a non-profit educational organization whose mission is to “Advance Ship Modeling Through Research”. We provide support to our members in their efforts to raise the quality of their model ships.

The Nautical Research Guild has published our world-renowned quarterly magazine, The Nautical Research Journal, since 1955. The pages of the Journal are full of articles by accomplished ship modelers who show you how they create those exquisite details on their models, and by maritime historians who show you the correct details to build. The Journal is available in both print and digital editions. Go to the NRG web site (www.thenrg.org) to download a complimentary digital copy of the Journal. The NRG also publishes plan sets, books and compilations of back issues of the Journal and the former Ships in Scale and Model Ship Builder magazines.

Our Emblem

Modelshipworld - Advancing Ship Modeling through Research
×
×
  • Create New...