Jump to content

needed an arbor for a slitting saw

Recommended Posts

Machined up a new arbor for a slitting saw to fit into my Clarkson milling collet slitting saw is .006" x 1.75" x .625"








The bore is 5/8th I machined down some 3/4 drill rod to 1/2 inch diameter then cut the treads close to size then chased them with a couple of different 1/2 x 20 dies


Polished it up and heat treated it to blue, I didn't have any short 1/4 20 bolts so machined one up out of some brass hex stock.





Current builds  Bristol Pilot Cutter 1:8;      Skipjack 19 foot Launch 1:8;       Herreshoff Buzzards Bay 14 1:8

Other projects  Pilot Cutter 1:500 ;   Maria, 1:2  Now just a memory    

Future model Gill Smith Catboat Pauline 1:8

Finished projects  A Bassett Lowke steamship Albertic 1:100  


Anything you can imagine is possible, when you put your mind to it.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Create New...