Advice on fixing a Poor Stain Job

Hi All! I am currently building model expos Norwegian Sailing Pram and I tried to stain the interior of the boat using MinWax Golden Oak. I didn't use a pre-stain but sanded and clean the interior. The result were super blotchy though and there seem to be areas of which refuse to take on any kind of stain. I did a practice run on the building board which came out great but I think my mistake was trying to stain the inside of the hull after it was already built. 1) Would another coat

Thanks for the insight everyone!!! I am going to try and do what Roger suggested and scrap the glue away/restain (I do appreciate having a nuclear option as well!) If not, I will probably going with Rylands and Jaegers advice on repainting. Do I need to worry about the areas that are already stained getting darker if I try and restain the spotty areas after scrapping off the glue? Should I try to be careful on re staining just the affected areas or does it not matter? I tested the