Engraving-Carving super fast machine !!!!

[stipecro]

What do you use for engraving figures ? Speed of ​​dremela and proxxon 25,000 rpm  is too small to controlled accuracy grinding !

 

I found this?

 

Engraving SCM 400xs engraver SCM’s high-speed 400,000 rpm handpiece gives you a smooth and controlled cut, through the entire operating range.!

 

or

 

Turbo CArver the same as SCM !

 

What do you normally use for engraving figure ?

[wefalck]

This is an air-turbine. You need a good compressor for it ...

 

wefalck

[stipecro]

This unique, ergonomically designed engraver was recently rated the number one high-speed engraver on the market today.

- 400,000 rpm

- Quiet

- Comfortable

- No in-line oiler

- No vibration.

- Air jets, Ergonomic Design.

The 400xs comes with, training videos, 3 diamond and 2 carbide bits, tubing, stencil paper, on/off switch and written instructions.

NOTE: The 400xs requires an air compressor to operate. It requires 1 cfm at 45 psi. A small compressor 3/4 HP or larger will work just fine.

 

 

if someone has this device or a similar brand ??????????