Norwegian Sailing Pram by Venti - Model Shipways - 1:12

[Venti]

Hello all!
It's time to start another one of these as I just got the boxes with the pram and smack in it! 😁

 

I just want to start this out by asking for a suggestion on desk vises. Specifically ones that will work for the pram, smack and then the larger size ships I will be doing more of in the futures. I used to have a nice ball vice to use for stuff but not sure if I want something as mobile as that for this hobby.

 

I've been going through the other build logs for it and read through the instructions already! Pretty excited to work through this one. One thing I've kind of annoying so far is that it's not clear at all which pieces are which on one of the wood sheets. There are multiple pieces that look like they could be the transom knees... or they could be stern/bow quarter knees... I thought it was the ones right next to the bottom half of the stern transom but it looked much smaller than in the pictures so I went with the two from the empty sections shown below. It looks correct comparing the transoms to the pictures in the book so we move forward!

 

Will update soon. Thanks in advance for all the help/suggestions!

 

[Venti]

Well quick update. It looks like most people in build logs are using the larger knee-looking piece with a hole in the corner for the stern transom knee... It looks better so I am going to swap to that as well.

[Kenchington]

2 hours ago, Venti said:

the larger knee-looking piece with a hole in the corner for the stern transom knee

Something is weird. My kit had the various knees labelled by the laser-cutter.

 

I can't give you definite answers because my sheet has been cut up as I needed scrap for various bits and pieces. However, I think that the two knees you had glued to the transoms before taking your photo are the stern quarter knees.

 

The stern transom knee is the one with the transverse hole laser-cut through it. (A hole that has no known purpose!) You seem to have two copies of that.

 

The pair of knees at the far left of your image are the ones that go on top of the midship thwart.

 

The bow transom knee is next in from those two, under the mould labelled "25".

 

The pair of knees just above where you took out the bow transom are the bow quarter knees.

 

But you should double check all that!

 

 

Trevor

[palmerit]

Check to see if you might have a part sheet in your box that has a map of the parts. I'm building a Midwest model (made by Model Expo too) and discovered that the instructions were quite different from the actual layout of the parts on the sheets and only then realized that there was another sheet in the box that in addition to having a parts list at the top had a map to a couple of the laser cut sheets at the bottom.

 

I also used the wrong knee when building the Pram. Good practice to undo some glue and try again. It's definitely a skill you'll use again - and just know that you can do it with a bunch of alcohol (if using PVA) or acetone (if using CA) with a few applications and some patience is a good skill to have. Also learn from my mistake and be careful using a scalpel or other sharp blade to remove a glued piece - on my Smack I had to remove a piece and it removed all at once and a blade went into my hand (just barely escaped with just a nasty scar without needing stitches).

[Venti]

Ah thank you so much you guys!

Yes you were right, Trevor.

 

And yes Palmerit, there is indeed a sheet with the the parts and it is labeled! That will be very nice moving forward...

 

I got the knees swapped out to the correct ones and added a couple strips to the bottom of the building board to make it a bit more sturdy. Credit: Kenchington

[OldeManToad]

I had the same problem with my Pram kit. I found this picture on the internet with the correct labeling.

 

 

Hope this helps.