Jump to content

Reference line on bulkheads

Recommended Posts

I am wondering if it's ok to just measure the distance from the top of the bulkheads to the reference line on the blueprint and then measure that same on the bulkhead and make my reference line mark? I have seen where others on here make templates from the blueprint to transfer the reference line. What is yalls opinion on this?


Link to comment
Share on other sites

I have done this in the past and then used a batten to get visual of the line. The bulkheads are usually close enough to get a good result.

David B

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Create New...