Jump to content

proxxon mf70 adapter

Recommended Posts



Do you know any adapter (eg. drill chuck) for micro miller MF 70 in order to admit miller cutter set (24610) with 6.0mm straight shank? This micro miller doesn't work with milling cutters upper to 3.2 mm.


Thanks in advance.

Link to comment
Share on other sites

If you have a lathe, you could turn yourself an end-mill holder that screws onto the thread on the spindle. The holder should be bored out to a tigh sliding fit for the mill shank, which would be held by three set-screws. However, the MF70 runs at speeds of 5000 to 20000 rpms, which might cause some serious balancing problems, so I would be rather not doing this. 



panta rhei - Everything is in flux



M-et-M-72.jpg  Banner-AKHS-72.jpg  Banner-AAMM-72.jpg  ImagoOrbis-72.jpg
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Create New...