Jorge Hedges Posted July 4, 2018 #1 Posted July 4, 2018 Hello All! Couple of pics to show my new setup... had an old Dremel drill press, and found in Amazon a simple, interesting compound sliding table. First tryout was pretty much good. Unit drilled right smack in the middle after the proper table adjustments were made. Can’t beat this with a $60 dollar setup! Next test will be a keel notch mill cut, when I have some scrap hardwood to try out; will keep you posted! F25AFB13-4B9B-49DF-9A61-93E05C7D80DA.MOV tasmanian, mtaylor and Canute 3 Quote
Moab Posted July 4, 2018 #2 Posted July 4, 2018 Than for posting. Great results...Moab Canute and mtaylor 2 Quote Completed Builds: Virginia Armed Sloop...Model Shipways Ranger...Corel Louise Steam Launch...Constructo Hansa Kogge...Dusek Yankee Hero...BlueJacket Spray...BlueJacket 26’ Long Boat...Model Shipways Under Construction: Emma C. Berry...Model Shipways
RichardG Posted July 4, 2018 #3 Posted July 4, 2018 I have both of these but they're sitting waiting for me to try them. Did you make any changes to the drill press? I find the Dremel isn't very rigid. Thanks, Richard Canute and mtaylor 2 Quote Richard Current Build: Early 19th Century US Revenue Cutter (Artesania Latina "Dallas" - messed about) Completed Build: Yakatabune - Japanese - Woody Joe mini Member: Nautical Research Guild & Midwest Model Shipwrights
Jorge Hedges Posted July 4, 2018 Author #4 Posted July 4, 2018 (edited) Nothing whatsoever. Just lubricated everything, tightened all screws a tad, and that is it. maybe a Sherline in the future... Edited July 4, 2018 by Jorge Hedges Canute, mtaylor and RichardG 3 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.