Amerigo Vespucci by DanielD - OcCre - 1:100

[DanielD]

15 hours ago, Bill97 said:

Thanks Daniel. I really like what you are doing with your AV and follow your lead a lot. Did you just toss all this OcCre thread or do you expect someday to have a use for it? 😊

Hi Bill, I tend to keep everything left over from each model. Sometimes I find a good use for the leftovers.

[Bill97]

Daniel what product did you use to attach your second planking?  On my first OcCre ship, the Endeavour, I just used the same wood glue I used to build the ship. It required patience and pins to hold each plank in place until the wood glue held.  I see in the OcCre videos they use some brand of contact cement to attach the second planking.  I have read other places where contact cement is not a great option. 

[DanielD]

52 minutes ago, Bill97 said:

Daniel what product did you use to attach your second planking?  On my first OcCre ship, the Endeavour, I just used the same wood glue I used to build the ship. It required patience and pins to hold each plank in place until the wood glue held.  I see in the OcCre videos they use some brand of contact cement to attach the second planking.  I have read other places where contact cement is not a great option. 

Hey Bill, I used Elmer’s Rubber Contact Cement. It is great, but it was hard to get the hang of using it so I think that is why some don’t like to use it. For me, I worked in small sections the length of the ship. Since the AV is a steel hull, there is no need to spend a ton of time making planks, so I used long plank sections from bow to stern. I started by drawing a line on the hull to place the first plank. Brush a thin coat of the cement on the back side of a couple planks and on the area along the hull for two or three planks. Let the glue dry! This is important! The glue will be dry to touch. Then carefully place a plank along the line that was drawn on the hull. Press the plank in place. Contact and pressure is what activates the glue, but it is permanent. You won’t be able to remove the plank without braking it into a bunch of pieces. Careful placement is critical! This is what makes it hard to use. However, once I got the hang of it, it was by far my favorite way to attach planks to the hull and I will use this technique on the next deck I do in the future. Again, once “pressed” in place, it’s immediately stuck and permanent and no wait time is needed between planks.

Edited 13 hours ago by DanielD

[Bill97]

Thanks Daniel. I will look into that. IAs I mentioned I used the wood glue on my Endeavour but wonder if OcCre’s recommendation to use contact cement for the second planking might be a better product to use. I have more positioning time with the wood glue but the flip side is I have to hold the planks in place with pins while it sets up a few minutes. The planks also tend to bow a bit as well. 

Edited 11 hours ago by Bill97

[Bill97]

Daniel I Googled Elmer’s Rubber Contact Cement but don’t find it. I find Elmer’s Rubber  Cement but not a contact cement.  The Elmer’s Rubber Cement does not read as if it is what you described.  Hummmm🤔

[DanielD]

1 hour ago, Bill97 said:

Daniel I Googled Elmer’s Rubber Contact Cement but don’t find it. I find Elmer’s Rubber  Cement but not a contact cement.  The Elmer’s Rubber Cement does not read as if it is what you described.  Hummmm🤔

Yes, rubber cement. It’s a type of contact cement, put glue on both pieces, wait for it to dry, and press together (contact) for the adhesive to activate.