Jump to content

Recommended Posts

Posted

Many years ago, I order a small set of laser cut blanks from the NRG as part of what I think was a Beginner's Carving Project but am not sure.  I know there were directions/instructions but can't remember if it was a PDF file or a build log here.

I've attached a photo of the item below.  The kit consisted of four sets of these.

I'm hoping someone recognizes this and can point me to a build log or a PDF.

Thanks,

Nathan

20250403_072907.jpg

Posted

This was available from Syren Ship Models (sponsor here) - I didn't see it with a quick check, but ask Chuck about it.

Kurt

 

Kurt Van Dahm

Director

NAUTICAL RESEARCH GUILD

www.thenrg.org

SAY NO TO PIRACY. SUPPORT ORIGINAL IDEAS AND MANUFACTURERS

CLUBS

Nautical Research & Model Ship Society of Chicago

Midwest Model Shipwrights

North Shore Deadeyes

The Society of Model Shipwrights

Butch O'Hare - IPMS

Posted

They are all here....

 

Its another tab above called "Tutorials and discussions for the carving group"

 

https://modelshipworld.com/forum/85-tutorials-and-discussion-for-the-carving-group/

 

And by the way.....Carving blanks are actually still available in the Syren store.

 

Chuck

Posted

I am busy until Mid May but maybe I will create some new designs to offer along with those initially offered.  And try to breath some new life into this group on beginner carving... 

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...