Archi
-
Posts
42 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Events
Posts posted by Archi
-
-
-
If anyone is interested in how I dealt with the problem with the MicroLux® Table Saw:
The problem of non-parallelism of the saw blade and guide grooves for Miter gage remains unsolvable. As a result, it is very difficult to use Rip Taper Gage and Sliding Table on the MicroLux® Table Saw.
-
Good photos !
Living in Ukraine more than 12 years ago, I used Proxon Table Saw FKS/E from Germany. Yes, with this saw there was no problem with parallelism, well, almost.
Then I started using its clone MicroLux® Mini Tilt Arbor Table Saw. It was because of the saw blade and the guide fence are not too parallel (and not only with my exemplar, a friend has the same problem) that I had to buy Byrnes tablesaw.But something bad happened: my wife lifted my Byrnes Table Saw right behind the fence🥵. And I discovered the already skewed the saw fence😖.
Now I will try to reinstall / readjust the Table Saw Fence. -
-
I repeat my old question: so when can we order Rogers Collection Volume Three ?
-
My condolences to the family.
- Canute and Ryland Craze
- 2
-
-
So when can we order Rogers Collection Volume Three ?
- mtaylor, uss frolick, michaelpsutton2 and 2 others
- 3
- 2
-
-
-
If suddenly someone has not seen:
https://ancre.fr/en/monograph/114-la-vo ... -1693.html
-
-
-
-
-
Byrnes tablesaw compares with Proxxon FET tablesaw
in Modeling tools and Workshop Equipment
Posted
Ok, thanks ! The deviation is approximately 0.13mm. I'll act taking this fact into account.