Jump to content

Schooner heads 1700s through 1800s


Recommended Posts

I have been trying to determine where the heads (latrines) were on small to mid sized schooners (60 to 100 foot between perpendiculars) from the late 1700s through the 1800s. I haven't found much information about them.

 

After the bows were closed in with no beakhead I wonder where the seats of ease went?

 

Here are a couple of photos of the Wawona from the Historic American Engineering Records (HAER). It was a three masted lumber schooner built in 1897 in San Francisco, CA, USA. The vessel had a fo'c'sle deck above the main deck at the bow. In this photo looking aft from the bow this overhead deck had rotted away, exposing the winch and the port side seat of ease to the elements. A short "bulkhead" afforded some privacy. Photos do not show the starboard area. The vessel rotted away and was scrapped.

 

 

1827602749_Wawonahead1.jpg.9cf5e629b3be67c941585f05872cea81.jpg

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

In this view looking forward (below) you can see the short bulkhead behind the ladder on the port side leading up to the fo'c'sle deck.

 

 

1158837643_Wawonahead2.jpg.f0d2bbb6d5be1f10a2edd5cca69ee80d.jpg

 

 

Photos of the hull do not show any openings in the hull side in the area where the seat of ease was located.

 

The Wawona was very similar to the C. A. Thayer that is in the nautical museum in San Francisco. But the HAER plans and photos for the Thayer do not show the seats of ease. They show one internal water closet in the aft cabin.

 

So the Wawona photos show one possible solution. Any one have examples of other heads on smaller ships that didn't have the elaborate beakheads like the larger ships?

 

PS: I read through the "Development of External Sanitary Facilities Aboard Ships of the Fifteenth to Nineteenth Centuries" thesis by Joe John Simmons III. It deals mainly with larger warships and has nothing about smaller vessels.

Edited by Dr PR

Phil

 

Current build: USS Cape MSI-2

Current build: Albatros topsail schooner

Previous build: USS Oklahoma City CLG-5 CAD model

 

Link to comment
Share on other sites

It is quite possible that buckets were used and that the seat of ease contained a bucket, rather than opening to the outside.

 

Sometimes small vessels had in later years small deckhouses at the forward bulwark one both sides (one may have been the paint-locker) with a half round roof. 

 

That's for 'serious' business, otherwise you just pee over the lee-rails or into the gutter ...

wefalck

 

panta rhei - Everything is in flux

 

 

M-et-M-72.jpg  Banner-AKHS-72.jpg  Banner-AAMM-72.jpg  ImagoOrbis-72.jpg
Link to comment
Share on other sites

Yes, it was important to choose the lee side!

 

I thought of the bucket idea and I am sure it was used on some ships. The "honey bucket" was in use in many households until the advent of running water and flush toilets. It would be "normal" to use them on ships.

Phil

 

Current build: USS Cape MSI-2

Current build: Albatros topsail schooner

Previous build: USS Oklahoma City CLG-5 CAD model

 

Link to comment
Share on other sites

Which reminded me of when I was a small child who read early. At my grandmother's was a shared toilet off the landing. The 'works' were a Victorian era extravaganza with a highly decorated bowl. I was mildly terrified to read the name of that particular piece of china. It read,  "The Shark". 

 

But we digress!

Edited by druxey

Be sure to sign up for an epic Nelson/Trafalgar project if you would like to see it made into a TV series  http://trafalgar.tv

Link to comment
Share on other sites

The Admiralty drawings for Haddock (1805) show two large cupboards at the stern, either side of the rudder. They are about 5 feet high, 2 feet wide and 2 feet front-to-back at the deck, more at the top. The one to starboard is labelled as a pantry while the one to port is called the 'necessary'. In the UK we now call the 'necessary' the toilet and in USA it is often called the bathroom. The drawing shows a door that opens forward so there was some privacy unlike the seats of ease in the heads. 

 

I have attached a pdf copy of a Masters thesis by Joe John Simmons about seats of ease. He wrote it in 1985 and it has plenty of detail for those who want to know including line drawingsSeats of Ease Simmons-MA1985.pdf. It's a good read while you are sitting at your leisure... 

 

George

George Bandurek

Near the coast in Sussex, England

 

Current build: HMS Whiting (Caldercraft Ballahoo with enhancements)

 

Previous builds: Cutter Sherbourne (Caldercraft) and many non-ship models

 

Link to comment
Share on other sites

George, that thesis is a breath of fresh air in this subject. Thank you for providing a ray of light on a shaded corner of the hobby of modelling.  👍 

Edited by bruce d

🌻

STAY SAFE

 

A model shipwright and an amateur historian are heads & tails of the same coin

current builds:

HMS Berwick 1775, 1/192 scratchbuild; a Slade 74 in the Navy Board style

Mediator sloop, 1/48 - an 18th century transport scratchbuild 

French longboat - CAF - 1/48, on hold

Link to comment
Share on other sites

That breath of fresh air might be needed ;)  Although, the sailors of old usually had lots of that, when going over that business.

 

Smaller boats, such as fishing boats had no facilities of any kind, one had to hang the bottom over the rails ...

wefalck

 

panta rhei - Everything is in flux

 

 

M-et-M-72.jpg  Banner-AKHS-72.jpg  Banner-AAMM-72.jpg  ImagoOrbis-72.jpg
Link to comment
Share on other sites

Phil, Bruce, 

 

The thesis makes many references to an article by Munday in "Ingrid and other studies" from 1978. Two websites claim to have pdf versions but a search suggests that the sites are scams and should be avoided. There are a few copies in Abebooks and various second-hand or charity shops for £15 - £20 but I do not have enough interest to increase my book collection on a minor topic. Do any of you have access to a copy? 

 

George

George Bandurek

Near the coast in Sussex, England

 

Current build: HMS Whiting (Caldercraft Ballahoo with enhancements)

 

Previous builds: Cutter Sherbourne (Caldercraft) and many non-ship models

 

Link to comment
Share on other sites

Had a good chuckle reading this. Back in the late 1960's I was stationed in Bahrein. Our sea angling club went fishing most weekends on one of the Arab Dhows. The "facilities" were a wooden crate roped to the stern with a couple of planks knocked out of the bottom,a bucket on a rope for performing ones ablutions.    At least the sea was warm there :D

 

Dave :dancetl6:

Link to comment
Share on other sites

George,

 

Thanks. I know that some schooners had similar "closets" at the stern, and at least one had something like this near the bow, port and starboard. But these were relatively large vessels (greater than 100 feet between perps). For smaller vessels I am inclined to agree with Wefalk about the "gold buckets."

 

I have read Simmon's thesis a couple of times to learn more about the subject. My favorite part is on pages 96-97 where a seaman was punished for painting an "uncaulked seam." It is hard to keep a straight face when pondering this subject.

 

The "Ingrid and Other Studies" paperback sells for $137.05 on Amazon. That's a lot of bread for a short article about heads.

Phil

 

Current build: USS Cape MSI-2

Current build: Albatros topsail schooner

Previous build: USS Oklahoma City CLG-5 CAD model

 

Link to comment
Share on other sites

On 6/15/2021 at 3:51 PM, Dr PR said:

George,

 

Thanks. I know that some schooners had similar "closets" at the stern, and at least one had something like this near the bow, port and starboard. But these were relatively large vessels (greater than 100 feet between perps). For smaller vessels I am inclined to agree with Wefalk about the "gold buckets."

 

I have read Simmon's thesis a couple of times to learn more about the subject. My favorite part is on pages 96-97 where a seaman was punished for painting an "uncaulked seam." It is hard to keep a straight face when pondering this subject.

 

The "Ingrid and Other Studies" paperback sells for $137.05 on Amazon. That's a lot of bread for a short article about heads.


 

Ingrid And Other Studies is $21 plus $14 shipping on Abebooks 

 

Plate V of the History Of American Sailing Ships by Howard I Chapelle shows a single seat of ease to either side of the bowsprit, on the head, on the Prince De Neufchatel.

DE0592A2-06BA-4C97-A258-9A56BE2C6000.thumb.jpeg.f275865acb3ec303b6ff248a23535a03.jpeg
Please ignore my notes.  This was my copy that I used to build the hull of my model.

Edited by GrandpaPhil

Building:

1:200 Russian Battleship Oryol (Orel card kit)

1:64 HMS Revenge (Victory Models plans)

1:64 Cat Esther (17th Century Dutch Merchant Ships)

Link to comment
Share on other sites

Thanks for the info. Chapelle's "History of American Sailing Ships" also shows a four-holer in the head of the Bainbridge in Figure 19 (page 123), and possibly "water closets" at the stern. I suspect that every ship that had a head also had seats of ease in the heads. But what about vessels that had no head?

 

The drawing of the Subtle (1808) on page 235 shows cabins or water closets at the stern. The vessel was 78 feet length on deck and 139 tons.

 

The Plate VIII (after page205) of the Joe Lane and the drawing on page 215 shows low stern water closets and lockers at the stern and more substantial two-holer water closets port and starboard just aft of the fo'c'sle deck. Joe Lane was a relatively large revenue cutter of 1851, 100 feet at the load water line and 153 tons.

 

The Wawona of 1897 had similar facilities. I suspect most/all vessels of about 100 tons or greater that did not have a head would have had similar water closet accommodations, but very few drawings depict them.

Phil

 

Current build: USS Cape MSI-2

Current build: Albatros topsail schooner

Previous build: USS Oklahoma City CLG-5 CAD model

 

Link to comment
Share on other sites

Some smaller vessels that had headwork did not have space for a head, The heads were located inside the bulwarks on the forecastle. An example of this is Speedwell of 1752. (From the Royal Museums Greenwich, Collections.)

 

image.png.3e4a98eccbd8592024c8b4581dc38a05.png

 

 

Be sure to sign up for an epic Nelson/Trafalgar project if you would like to see it made into a TV series  http://trafalgar.tv

Link to comment
Share on other sites

Druxey,

 

Thanks. That is what I suspected, and enlarging the image of the foc's'le I can see a seat of ease port and starboard aft of the catheads. No covers or "closets". Not much more than a pissdale with a seat.

Phil

 

Current build: USS Cape MSI-2

Current build: Albatros topsail schooner

Previous build: USS Oklahoma City CLG-5 CAD model

 

Link to comment
Share on other sites

  • 1 year later...

In 1965 I was the Boat Puller aboard the 'Cape Race' out of Bellingham, WA., She was a 36' long  King Salmon troller. We took her to SE Alaska for the season and brought her back that fall. She was equipped with a head, used for storage, the facilities were a bucket with a line attached to the bail, kept handy, leaks were done over the lee side, if underway or anchored out, if in populated areas the bucket did double duty. Just toss it in the drink to get several inches of water in it, do your duty and over the side it went for a good rinsing, had to watch the speed of the boat to prevent it from becoming a sea anchor. Only two aboard, no problem. I would suspect that in the days of old an assortment of provisions for relieving yourself without fouling the vessel or going overboard was the norm. Those provisions were probably a reflection of the ships rig which created different yet predictable wet areas, that were avoided.

 

Edited by jud
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...