filling gaps in deck planking

[Benjamin sullivan]

Hello I am working on the deck of my model ship and i have a few unwanted gaps.

I was wondering what the best filler would be .

thanks

Edited November 3, 2022 by Benjamin sullivan

[mtaylor]

Generally for planking on the hull or deck, I find a mix of sawdust (appropriate wood of course) and mix up some white glue and water at 50-50.  Make a slurry of the sawdust and glue mix and fill the gap.  Actually fill over the gap then sand when dry.  If it's not a wide gap, just put some of the glue mix in the gap and sand the wood.  The sanding dust will go into the gap and hide it.  As always, your mileage may vary to test first if possible on a hidden part of the hull/deck.

[No Idea]

I echo what Mark has said above but I do mine very slightly differently.  I mix very fine sawdust that I make with a Dremel sanding drum into the PVA and use as much sawdust as possible.  It kind of turns into a very thick putty that I then push into the gap with a very flexible knife.

 

Its exactly the same thing but it just has a greater content of wood which I would guess at 75% wood - 25% PVA.  It does however make it quite hard to sand down as its very tough but the results are pretty good.

Edited November 5, 2022 by No Idea
Typo error

[allanyed]

Benjamin

How wide are the gaps?  If a few thousandths in one or two spots, the idea of sawdust is used by many of us in different ways.  If it is more than this why not remove the errant planks redo them without gaps?   

Allan

[Benjamin sullivan]

there are only a few small gaps so I think I will fill them with sawdust.

thank you for the replies.