F-84G by Javlin -Tamiya - 1/48 - PLASTIV

[Javlin]

I have been building this one while doing the George  was really liking the look alot just shiny enough and the same clear same bottle the last coats lost a shade of shine.The pic on the stand is right before the last clear 🤨

[ccoyle]

Looks great!

[TOM G]

18 hours ago, Javlin said:

the last coats lost a shade of shine.

You can use , Pledge floor care in a air brush and get a good shine.

[Javlin]

1 hour ago, TOM G said:

You can use , Pledge floor care in a air brush and get a good shine.

I have used that in the past the experiment seemed to be working till the last coats Tom don't know why?

[TOM G]

21 hours ago, Javlin said:

seemed to be working till the last coats Tom don't know why?

Look's like what is happening is the air brush needle point tip is loading up. ( this reduces your volume output making a dryer coat ) This will realy hapen bad when you set the air brush to the side, waiting for flash time between coats. Take the front end apart clean it, and if your going to set the brush to the side for flash time.... spray Windex through it.  Also make sure you have the right needle in the brush, you want the one for a high volume cause your covering a large area.

[Javlin]

3 minutes ago, TOM G said:

this reduces your volume output making a dryer coat )

I may of used a different AB  on the first coats now you mention it that had a higher volume?🤨