Starcraft Adjutant AI by yvesvidal - 1/6 - RESIN/PLASTIC

[Landlubber Mike]

Very cool - you certainly picked a complex print!  Nice job!

[yvesvidal]

19 minutes ago, Landlubber Mike said:

Very cool - you certainly picked a complex print!  Nice job!

Mike,

yes, it is most definitely a very difficult kit to print and put together. Thank you for the compliments.

Yves

[RGL]

Fabulous 

[yvesvidal]

I am now spending some time on the AI creature, starting with her Mohawk, on the back of her head: 

 

 

I suppose this Mohawk is a massive radiator for the computer and chips installed in her cranium.

 

Then, I move to the rear sides of her armor: 

 

 

These are glued in place, using the chest to position them exactly. Most of the armor plates are removable and secured by magnets, but not these two pieces that need to be perfectly installed and glued so that all other parts of the armor can fit. To do that task, I removed the shoulders and you can see the Orange LEDs protruding out, on each side.

 

 

Once glued, a few pictures: 

 

 

And with her little skirt in place (held by magnets): 

 

 

 

Yves