Supplies of the Ship Modeler's Handbook are running out. Get your copy NOW before they are gone! Click on photo to order.
×
kiwiron
-
Posts
696 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Events
Everything posted by kiwiron
-
Thanks, small mistakes from early on showing up now but can be fixed. I didn't find the gun ports linings to bad, just gentle with the 16mm walnut. Only a few linings lost into the hull out of 288. Hope I can do a decent waterline mark out. Ron. -
Nice job, I am about at the same stage.
-
Incredible workmanship, stunning to see. Thank you.
-
Starboard gun ports done, now to carry on the production line port side.
-
Wales done now after a break, onto the gun port linings. Rudely interrupted by going to work.
-
First side of lower wale done.
-
Very nice work, I liked my Occre Endeavour but found the dimensions in the Occre booklet did'nt match the plans. So lesson learned go by the plan sheets for dimensions.
-
Thanks lol, I'm trying but a lot of other Victory builds on here are amazing. I get a difficult piece and think it's a mess but by the time I use filler and later on paint it should'nt be too bad. I do enjoy most of it.
-
Good one, thanks a lot. I managed to find some 1.5 x 2mm, all good now at the hobby shop. Must have a look at your builds to check my wale line for the top position of the bottom Wale.
-
Replacement castings from kit supplier. Hobbies.co.uk have been great getting these for me. Looking at using some 1.5 x 1.5 walnut supplied in kit for waterways but worried about running short later on. Has anyone finished theirs and had spare left over? Thanks Ron.
-
Wales next, paint later on after finding something for the waterways.
-
Gun ports linings on,dry fit camber beams. Next clean up gun ports, sanding, painting.
-
Inner gun ports linings next.
-
4 butt shift planned out. Trial of quarter deck.
-
Small update.
-
The cast piece broken off wasn't in the plastic bag or I could of just glued it.
-
Yup, just the cast piece I really need.
-
Thanks for the advice. Need to file my ports a bit more yet. The wooden part sheet is being sent. I was waiting for the Amati kit but no idea when that will be available.
-
Found more broken parts. Quality control is poor. No answer to emails to Jotika but supplier of kit has been very good.
-
Inner port linings trimmed at the bottom. Onto the upper deck once I get my tennis elbow surgery done.
-
Major sanding today, Happy with the hull shape now. Thanks Graham, I spend lots of time looking at your great build log.
-
Closing in a bit. Cut planks until waterline then whole lengths as I will copper the hull.
Our Emblem ®
