New here, checking the place out

[jbassett]

Good evening from the East Coast US-

New ship modeler here. I got into the hobby a little by accident. I was browsing the Dumas site a few months ago looking for a rubber-band powered airplane kit to buy and build. In the checkout, since shipping was extra, I thought to myself "what else should I buy if shipping is a flat rate?"

And so it began. I started with their sailboat model 1007 as it was for a junior modeler. I figured I would have no problems putting together something meant for a kid!

I thought I followed the instructions closely- but definitely should have sought further advice before starting the kit. It looks like crap! But that's ok! It was cheap and my first time building a model boat. I don't have a picture on hand, but trust me when I tell you: It's bad.
Fast forward a few weeks, I think to myself, "Self! You should try another boat!"

But before doing so, I found a sheet of galvanized and some magnets to help me line things up a bit better and hopefully make fewer mistakes in the next one. I also 3d- printed a few parts and pieces to help hold frames and the keel in place while gluing.

As a second model, I chose the Ace Sloop from Dumas. Another fairly easy (slightly more expensive) model, and this one, once finished, I can take to a small pond nearby and watch it go where the wind takes it.

It's not perfect, the frames are not perfectly aligned (not square to the keel). The die cuts are not perfect (I suspect that no die cuts are) so I fashioned some shims from scrap so the keel cut-outs were the right size for the keel.

I unfortunately did not notice until putting the bottom on the model. The sides are already on and trimmed flush to the frames and the best way to describe it is that it is a bit .. wonky.

I am going to keep building on and see what more I can learn from but at least model #2 is a huge improvement over model #1.

Learning has occurred! 
My biggest takeaway from all of this... take more time to get things right before gluing. I have also added a square to my tool kit. 

Next in the queue: A Midwest Sea Bright Dory.

I aspire to one day build an RC Chris Craft boat (not sure which one yet) or a Riva Auquarama. The examples on this forum are stunning and I hope to build the skills required to make something nice.

Apologies for the long-winded introduction!
John

 

Edited 20 hours ago by jbassett
spelling

[Knocklouder]

Good luck on your journey.   

Bob  M.

Edited 20 hours ago by Knocklouder

[vossiewulf]

Welcome John! Ships are kind of the final boss on the modeling tree, the challenge ranges from "hmm that's tricky" to "OMG I think my eyes are bleeding"  Have fun and go slow and read others' build logs to see what tools and techniques they're using, there are some extraordinarily good builders here.

[Louie da fly]

Hi John, and welcome to MSW.

 

You've made a good start. As you improve your skills you'll be able to take on more and more advanced builds, but don't be upset if you continue making the odd mistake. Everybody does - it's one way to learn. Preferably to learn so you don't make the same mistake again (though of course even that's not a given).  The main difference is that the more experienced modellers make much more interesting mistakes.

 

And enjoy the journey. It's something between a whole new exciting adventure and a whole new exciting can of worms. Depends on the day . . .

 

And I'd recommend you start a build log for your next one. A great way to get feedback and advice from people who've been there before - the people here are very helpful and friendly - and we get to see your model under construction. Always a good thing. 

 

Steven

Edited 19 hours ago by Louie da fly

[Jim Lad]

Hello John, and another warm welcome to the form from 'Down Under'.

 

John

[GrandpaPhil]

Welcome!

[Baker]