SOLEIL ROYAL by Robert Taylor - Heller - 1/100 scale - PLASTIC - side project

[kirill4]

Sorry for my too late question regarding ratlines thicknest ...

May be  this " check point "  question will be usefull for the next model... 

All the best!!!

[yvesvidal]

Incredible model and assembly. You are turning this Plastic kit into a little marvel: Pimping it up, should I say !

 

I remember assembling the Heller Royal Louis some fifty years ago, but it was far from your level of expertise.

 

Looking at the stern of that vessel, one can see the differences of richness and decorations between the French and British vessels. The French builders were definitely putting more emphasis into the glamor and opulence. That "Chateau Arriere" is absolutely amazing.

 

Yves

[Robert Taylor]

On 12/17/2024 at 8:36 PM, yvesvidal said:

Incredible model and assembly. You are turning this Plastic kit into a little marvel: Pimping it up, should I say !

 

I remember assembling the Heller Royal Louis some fifty years ago, but it was far from your level of expertise.

 

Looking at the stern of that vessel, one can see the differences of richness and decorations between the French and British vessels. The French builders were definitely putting more emphasis into the glamor and opulence. That "Chateau Arriere" is absolutely amazing.

 

Yves

Thank you very much for your kind words Yves. I have also built the Heller Royal Louis a few years back to which I improvised on that kit too when still finding my feet bk in modelling after a 40yr absence. I didn't  improvise as much as on this Soleil Royal kit obviously because of the scale difference. Here is some photos  of my Royal  Louis 1/200 Heller kit finished.

[Robert Taylor]

SOLEIL ROYAL UPDATE : 

the Lower ratlines are now complete from the Spritsail, Foremast, Main and Mizzen mast, with 942 clove hitches being tied in the process.
Now moving on to rig the deadeyes/shrouds for Top masts of the Fore, Main & Mizzen.

[Robert Taylor]

Just rigging up the deadeyes for the Fore topmost Shrouds in my usual unorthodox way. The modelling wire on the lower deadeye will go through the hole on the crowsnest then I will bend it up into a loop, where I can then tie the Futtock Shrouds from, this is the same way I rigged the futtock Shrouds on my Occre Endeavour build.
The 2nd pic below is for information only as to what I mean, not taken from my Endeavour build.

 

 

Edited December 31, 2024 by Robert Taylor
Improvised text