Jump to content

Recommended Posts

Posted

The below drawing happens to be the Artois, but it is similar to many others.  Is there a name for the line marked below.  I have traced it in magenta on the profile plan to see if I could figure it out, but it does not seem to hold any significance.   I am sure it has significance as lines were not arbitrarily drawn on these plans so I am curious to know what it is about.  The deck line can be seen in red on the original plan so it is not the deck. 

TIA

 

Allan

 

Line question AAA.PDF

PLEASE take 30 SECONDS and sign up for the epic Nelson/Trafalgar project if you would like to see it made into a TV series.   Click on http://trafalgar.tv   There is no cost other than the 30 seconds of your time.  THANK YOU

 

Posted

Allan,

 

I am not an expert in this area, but I have encountered the same line on my Crocodile draft.  I have interpreted it as the top of the moulding that is even with the bottom of the midship rail. Once the moulding diverges from the rail at the waist it continues aft to the quarter galleries and forward to a point above the stem.  I'm not sure if that moulding is called the "drift rail?"

 

Adam

Posted

Given that there is not all of the interior drawn in red,  that the line shows no reference to the outside rails and mouldings, that it is all on the same level, and that it is at the correct distance above the gunports -  I believe  that it is the underside of the deck at the side.

 

NRG member 50 years

 

Current:  

NMS

HMS Ajax 1767 - 74-gun 3rd rate - 1:192 POF exploration - works but too intense -no margin for error

HMS Centurion 1732 - 60-gun 4th rate - POF Navall Timber framing

HMS Beagle 1831 refiit  10-gun brig with a small mizzen - POF Navall (ish) Timber framing

The U.S. Ex. Ex. 1838-1842
Flying Fish 1838  pilot schooner - POF framed - ready for stern timbers
Porpose II  1836  brigantine/brig - POF framed - ready for hawse and stern timbers
Vincennes  1825  Sloop-of-War  - POF timbers assembled, need shaping
Peacock  1828  Sloop-of -War  - POF timbers ready for assembly
Sea Gull  1838  pilot schooner - POF timbers ready for assembly
Relief  1835 packet hull USN ship - POF timbers ready for assembly

Other

Portsmouth  1843  Sloop-of-War  - POF timbers ready for assembly
Le Commerce de Marseilles  1788   118 cannons - POF framed

La Renommee 1744 Frigate - POF framed - ready for hawse and stern timbers

 

Posted
1 hour ago, Jaager said:

I believe  that it is the underside of the deck at the side.

BINGO!

 

I knew that....once. :(

 

Craig.

 

I do know, that I don't know, a whole lot more, than I do know.

 

Current Build: 1:16 Bounty Launch Scratch build.   1:16 Kitty -18 Foot Racing Sloop   1:50 Le Renard   HM Cutter Lapwing 1816  Lapwing Drawings

Completed....: 1:16 16' Cutter Scratch build.

Discussion....: Bounty Boats Facts

 

 

 

Posted

Sorry guys it is not the deck.  The deck line (top and bottom of the planking) is shown in red on the original draft.  I will zoom in further to see if it helps.  Will mark the line in question with arrows Druxey, good point.

Thanks

Allan

 

Line question BBB.PDF

PLEASE take 30 SECONDS and sign up for the epic Nelson/Trafalgar project if you would like to see it made into a TV series.   Click on http://trafalgar.tv   There is no cost other than the 30 seconds of your time.  THANK YOU

 

Posted

Assuming you are correct Craig, and I think you are, I cannot believe how stupid of me not to just take the line all the way through to see such a basic thing by myself.  

Allan

 

PLEASE take 30 SECONDS and sign up for the epic Nelson/Trafalgar project if you would like to see it made into a TV series.   Click on http://trafalgar.tv   There is no cost other than the 30 seconds of your time.  THANK YOU

 

Posted (edited)

My first given was incorrect.  There are red lines.  I missed that.

Struck out!

Drift:

I can't think of any use that I would have for the shear line?

 

 

Edited by Jaager

NRG member 50 years

 

Current:  

NMS

HMS Ajax 1767 - 74-gun 3rd rate - 1:192 POF exploration - works but too intense -no margin for error

HMS Centurion 1732 - 60-gun 4th rate - POF Navall Timber framing

HMS Beagle 1831 refiit  10-gun brig with a small mizzen - POF Navall (ish) Timber framing

The U.S. Ex. Ex. 1838-1842
Flying Fish 1838  pilot schooner - POF framed - ready for stern timbers
Porpose II  1836  brigantine/brig - POF framed - ready for hawse and stern timbers
Vincennes  1825  Sloop-of-War  - POF timbers assembled, need shaping
Peacock  1828  Sloop-of -War  - POF timbers ready for assembly
Sea Gull  1838  pilot schooner - POF timbers ready for assembly
Relief  1835 packet hull USN ship - POF timbers ready for assembly

Other

Portsmouth  1843  Sloop-of-War  - POF timbers ready for assembly
Le Commerce de Marseilles  1788   118 cannons - POF framed

La Renommee 1744 Frigate - POF framed - ready for hawse and stern timbers

 

Posted
6 hours ago, allanyed said:

I cannot believe how stupid of me not to just take the line all the way through to see such a basic thing by myself.

How do you think I feel? I worked this out months ago and then forgot :(

Craig.

 

I do know, that I don't know, a whole lot more, than I do know.

 

Current Build: 1:16 Bounty Launch Scratch build.   1:16 Kitty -18 Foot Racing Sloop   1:50 Le Renard   HM Cutter Lapwing 1816  Lapwing Drawings

Completed....: 1:16 16' Cutter Scratch build.

Discussion....: Bounty Boats Facts

 

 

 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...