Jump to content

aviaamator

Members
  • Posts

    710
  • Joined

  • Last visited

Everything posted by aviaamator

  1. Great job! I really like to look at the machining process!
  2. Vitaliy Ignatovich! Please, pass Melnikov'у hello from Petrozavodsk!
  3. Apparently, my "English" "lame", i meant that the covering boards vessel must close out board transom from the outside. Sorry! My vision too bad...
  4. I am sure that the trim strips are wrong, the strap should cover boards transom.
  5. A few hours was looking through this blog... I Admire the work done!
  6. Reread Your topic, and again found something new for myself! Clamp very much! Thank You! :D
  7. Dispel my doubts about the lack of curvature of the deck of the Corvette and cross-sections, please...
  8. The best helper for us, this book is Peterson. Also there are no scuppers, there is no radius on the deck. Etc. P.S.Sorry if this was rude...
  9. Dear colleagues! Realize I'm late with the advice, but I built the "Virginia," not exactly according to the instructions from the manufacturer( artesania latina). Knize anchor biting need to deploy 180 degrees. Other inaccuracies while quiet. To my regret, can not use the expanded form of the answer to show photos, alas...
  10. I have a problem with messages... And now have not... In fact : amazing simply!!!
  11. I also have prodused such a drill from medical needles. Result is great !!!
  12. Photoetch from "Eduard", Czech Republic - very good quality! (not advertising).
  13. Great! Hands grow in the right direction!
×
×
  • Create New...