USS Constitution by mtbediz - 1:76

[mtbediz]

17 minutes ago, Thukydides said:

Very nice. Those are some nice neat joints.

Thanks! With my milling machine, I can get these joints looking sharp and clean.

[Der Alte Rentner]

Hello Mustafa, I didn't want to copy the photos from your post after you installed the channel caps and clutter up your build log, but I have a question. Did you taper the channels from the hull to the cap? It doesn't seem to me that you did, which is perfectly fine by me. I'm just looking for justification to follow in your footsteps.

 

Since I can't cover up mistakes with black paint, I have to very carefully consider the steps involved in attaching the channels, chain plates, dead eyes and caps.

 

If you did taper, it's hard to see in those photos..

 

Thanks in advance.

[mtbediz]

I'm taking a break from working on the masts and tops for a while to complete some of the other missing parts. Right now, I'm fabricating the main brace bumpkins and the stern boat davits.

[JSGerson]

You don't disappoint, they look gorgeous!

 

Jon

[GGibson]

Great work, Mustafa! 

[Scallywag]

You do beautiful work.

[mtbediz]

On 10/13/2025 at 4:23 PM, Der Alte Rentner said:

Hello Mustafa, I didn't want to copy the photos from your post after you installed the channel caps and clutter up your build log, but I have a question. Did you taper the channels from the hull to the cap? It doesn't seem to me that you did, which is perfectly fine by me. I'm just looking for justification to follow in your footsteps.

 

Since I can't cover up mistakes with black paint, I have to very carefully consider the steps involved in attaching the channels, chain plates, dead eyes and caps.

 

If you did taper, it's hard to see in those photos..

 

Thanks in advance.

Sorry Peter, I just noticed your post. I don't know why, some posts appear much later in my build log. I guess this is one of them.  No, I didn't taper the channels. I didn't even know they needed to be tapered.

Edited Friday at 04:33 AM by mtbediz

[Der Alte Rentner]

9 hours ago, mtbediz said:

Sorry Peter, I just noticed your post. I don't know why, some posts appear much later in my build log. I guess this is one of them.  No, I didn't taper the channels. I didn't even know they needed to be tapered.

Oh snap!  My bad.  I just double checked the Hunt practicum and learned that I misread that portion of the instructions.  The channels are tapered, yes, but only by 1/16" of an inch at their fore and aft edges.  Sorry abut the miscue.