Figurehead of the USS Confederacy (1778)

[igorcap]

Figurehead of the USS Confederacy (1778). Scale 1:64

[allanyed]

Lovely drawing Igor!  I think the knee of the head is supposed to taper to about half the width, or less, than the width of the stem by the time it reaches the forward most point of the bobstay.  (see white lines on the below picture.

Again, your drawings are wonderful!!      Allan

[igorcap]

Thanks Allan!
Yes, your remark is correct. The figure is not finished yet, the customer must give me the exact dimensions of knee of the head, after that I will correct the figure in place.

[igorcap]

The rest of the decor

[igorcap]

Decor set for USS Confederacy (1778). Now in the wood (pear). Scale 1/64

[WalrusGuy]

4 hours ago, igorcap said:

Decor set for USS Confederacy (1778). Now in the wood (pear). Scale 1/64

Looks amazing! Are you planning to sell these? 

[igorcap]

Yes, the kit is on sale. If you are interested, write in private messages

[charlotte isringhausen]

On 8/17/2021 at 2:47 PM, igorcap said:

Yes, the kit is on sale. If you are interested, write in private messages

         i'm  interested in buying the kit.

[Jim Lad]

Charlotte, I've removed your private email address from your post. remember that this is a public forum and you are sharing your personal details with the world.

 

Please contact igorcap via a private message.

 

John

[bear]

Hello All

 

Igor made this set for my Confederacy and you can be sure of his quality and prompt service. I am working on my Confederacy now. 

 

I am working hard to get to the point where I can mount the wonderfull set of his carvings to my hull.

 

Keith  in Troutdale with Boris