Jump to content

HMS Winchelsea by scrubbyj427 - 1:48


Recommended Posts

  • 1 month later...
Posted (edited)

Beautiful and inspiring work almost comes to an end JJ….

I wonder if you could explain and visualize two things:

1. The connection of your 9-12 Volt connector to your model stand and how you wired the male/ female plug inside the winnie (did you drill the wiring all the way vertical through the keel AND the multiply?)

2. A small tutorial on how to produce those lovely lanterns hanging all over?

The rest of the wiring is clear in your pictures I think.

Thanks, Frank.

 

Edited by FrankWouts

Current builds on MSW:

HMS Winchelsea 1:48

Prior builds on MSW:

None

Link to comment
Share on other sites

  • 3 months later...
On 3/24/2024 at 6:48 PM, FrankWouts said:

Beautiful and inspiring work almost comes to an end JJ….

I wonder if you could explain and visualize two things:

1. The connection of your 9-12 Volt connector to your model stand and how you wired the male/ female plug inside the winnie (did you drill the wiring all the way vertical through the keel AND the multiply?)

2. A small tutorial on how to produce those lovely lanterns hanging all over?

The rest of the wiring is clear in your pictures I think.

Thanks, Frank.

 

Hi Frank, my sincere apologies for not responding to this, I somehow let it slip through the cracks.

 

To answer your questions, I bought a 9volt battery plug and connector from Evan’s LED (on msw vendor list), I did indeed carefully drill from the bottom of the keel up and out the side of the bulkhead former.

These parts are very small so I drilled two small holes and then used a No.11 blade to carve out a square hole in which the female end of the electrical plug would permanently fit. As you can see in my build log, there is a series of feeder wires that supply all the lanterns throughout the model that I ran up through the spirketing and into the deck beams where then feed the lanterns.

The lanterns are 3D printed and I’m happy to share that file with you, I used Evan’s chip leds, smallest available ( I believe) to simulate a warm candle light.

 

i hope this helps, now is the time to begin  installing all this wiring, I think just before chapter 4. It was a very difficult task to hide all these micro wires successfully so take your time.

JJ

Current Builds: HMS Winchelsea 1764 1:48 - 5th rate 32 gun frigate (on hold for now)

 

                         HMS Portland 1770 Prototype 1:48 - 4th rate 50 gun ship

 

Link to comment
Share on other sites

  • 3 months later...

Think I’m going to jump in tomorrow or the next day. Most of my tools are still in the mail. But I got her out of her crate and back on the bench.

IMG_7722.jpeg

Current Builds: HMS Winchelsea 1764 1:48 - 5th rate 32 gun frigate (on hold for now)

 

                         HMS Portland 1770 Prototype 1:48 - 4th rate 50 gun ship

 

Link to comment
Share on other sites

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...